Cure Type
: Room Temperature cure after mixing
Viscosity
: 3,194,000 (cps)
Standard Shelf Life (In Days)
: 730
Shear Strength
: 17.0 N/mm2
Specific Gravity
: 2.5 to 2.71 @ 25˚C
Open Time
: 20 mins after mixing
Country of origin
: India
Manufacturer
: Henkel Adhesives Technologies India Private Limited D3/D4, MIDC Industrial Estate, Jejuri, Purandhar, Pune, Maharashtra - 412303
MRP
: Rs. 15 601.00 (incl. of all taxes)
Customer Support
: Phone Number: 1800 2333 562,
Email ID:
customer.enquiries@henkel.com,
Address: Customer Support Executive, Henkel Adhesives Technologies India Private Limited L&T Seawoods, Grand Central Tower 1, 401, B wing, 4th Floor Seawoods Navi Mumbai - 400706 Maharashtra
Unit Selling Price
: Rs. 15.60 per gram (incl. of all taxes)
Cure Type
: Room Temperature cure after mixing
Viscosity
: 3,194,000 (cps)
Standard Shelf Life (In Days)
: 730
Shear Strength
: 17.0 N/mm2
Specific Gravity
: 2.5 to 2.71 @ 25˚C
Open Time
: 20 mins after mixing
Country of origin
: India
Manufacturer
: Henkel Adhesives Technologies India Private Limited D3/D4, MIDC Industrial Estate, Jejuri, Purandhar, Pune, Maharashtra - 412303
MRP
: Rs. 15 601.00 (incl. of all taxes)
Customer Support
: Phone Number: 1800 2333 562,
Email ID:
customer.enquiries@henkel.com,
Address: Customer Support Executive, Henkel Adhesives Technologies India Private Limited L&T Seawoods, Grand Central Tower 1, 401, B wing, 4th Floor Seawoods Navi Mumbai - 400706 Maharashtra
Unit Selling Price
: Rs. 15.60 per gram (incl. of all taxes)
How to use LOCTITE® EA 3478?
Remove dirt, oil, grease, etc. with a suitable cleaner, e.g. high pressure water cleaning system using Loctite® SF 7840™ (Loctite® Natural Blue® cleaner/degreaser). Blast all surfaces to be coated with a sharp edged angular grit to a depth of profile of 75 to 100 microns and a degree of cleanliness of Near White Metal (SIS SA 2½ /SSPC-SP 10). After blasting, metal surfaces should be cleaned with waterless cleaner, e.g. with Loctite® SF 7611™ (Loctite® Pro Strength Parts Cleaner), and be coated before any oxidation or contamination takes place. Metal that has been in contact with salt solutions, e.g. seawater, should be grit blasted, high-pressure water blasted, and left for 24 hours to allow any salts in the metal to sweat to the surface. A test for chloride contamination should be performed. The procedure should be repeated until chloride concentration on the surface is below 40 ppm. Mix 4 part resin to 1 part hardener by volume (7.25 to 1 by weight) or transfer entire kit onto a clean and dry mixing surface and mix thoroughly until color is consistent. Apply fully mixed material to prepared surface.